撞護欄波形護欄板成型機生產線

三、 主要技術參數及組成equipment main component technic parameter：

1、開卷機uncoiler：

采用雙錐開卷機，載重10T，單向手動調節及電動壓緊固定卷帶。由雙錐面，轉動軸，滑動機架，軸孔座，調節螺桿，底座等組成。擺線針輪減速機3kw電機。采用傳動調節絲桿固定卷帶。

Use double-cone uncoiler, rated load is 10t,one-way manual adjust and electric press to fixation the coil. Consist of doule-cone surface, rotating shaft, sliding frame, boss, adjusting screw ,chis and etc.. Cycloidal pin wheel reducer 3KW motor, use tranission adjusting screw to fixation coil.

2、動力九輥整平機power 9-roller leveling machine：

前對輥夾送，后七輥校平，可板材平整，便于沖孔，沖孔。手動調節對輥及整平輥，齒輪傳動。由軸，機座齒輪，制動器，減速機，電機等組成。墻板材質為A3鋼板加工；輥軸材質為40Cr，淬火處理HRC54，整體淬火；齒輪高頻淬火；用?300制動器；ZQ350減速機；11kw-6電機。

Front two opposite rollers for clamping and conveying, back 7 rollers for leveling, which can ensure the leveling and flatness of sheet material, and convenient for punching, therefore ensure the punching hole precision. Manual adjust opposite rollers and  leveling rollers, gear tranission. Consist of shaft, engine base gear, braking device, reducer, motor and etc..Wall plate material use A3 steel plate machining. Roller material is 40Cr, quenching treatment HRC54, whole body use quenching treatment. Gear high frequency quenching, use ?300 braking device, ZQ350 reducer, 11kw-6-pole motor.

3、 液壓沖孔機 hydraulic punching machine：（外購purchased）

采用YL32-315四柱液壓機，配沖孔模具三波1付，可沖十孔與九孔。沖模材質Cr12MoV，硬度為HRC58-60。

Use YL32-315 four column hydraulic machine, with punching mould three-wave one set, which is applicable for both 10 holes and 9 holes. Punch dies material use Cr12MoV, hardness is HRC58-60.